Plenty of producers experiment with 432Hz and then quietly stop, usually for the same reason: they tried it at the wrong point in the beatmaking process and concluded it did not work. The tuning is not the problem. Placement is.

When to tune a beat

There are three workable moments, and they are not equally good.

Last, on the master bus

The simplest option. Finish the beat, then apply the shift to the finished mix. One plugin, one decision, easy to A/B. This is the right approach for most producers and the one 432Hz MASTER is designed around.

On a mix bus, while mixing

Apply the retuner to a bus before your final limiting so you hear the shifted version while making balance decisions. More control, slightly more work.

Per track, selectively

Shift melodic elements and leave percussion alone. Useful when you like the character of the shift but want your kick and hats to stay exactly where they were trained.

Tuning drums to a beat

The most common technical question. If you are building drums against an existing loop, you have two options:

  • Resample the loop to match your tempo. This changes pitch as a side effect, which is why loops sometimes end up at odd pitches.
  • Retune the whole beat instead. Print the beat and apply a pitch shifter, preserving tempo. This is usually cleaner and much faster than nudging every drum hit by hand.

When drums drift out of key with the tonal material, a global shift keeps everything in proportion because every element moves by the same ratio.

A global pitch shift keeps everything in proportion. Nudging individual hits by ear never will.
Vibrant waveform energy representing beatmaking with retuned audio at 432Hz
Every element moves by the same ratio, so the groove stays intact while the pitch shifts.

A practical 432Hz beatmaking workflow

1

Build and arrange the beat at standard 440Hz as normal.

2

Mix properly, and leave a few dB of headroom below your limiter ceiling.

3

Print the mix, or commit to the master bus with the retuner in bypass.

4

Engage the retuner after your limiter so it is the last stage.

5

Listen three times through before deciding. The character shift is subtle and cumulative.

Using both references in one catalogue

Some producers keep two versions of the same beat, which is perfectly reasonable. 432Hz MASTER gives you the universal tuning version and RASTA 528Hz gives you the Solfeggio reference. Because both preserve tempo, exporting a second version takes seconds rather than a fresh mixdown.

Whichever you choose, decide on the second listen. The difference is real but modest, and your first impression is rarely reliable.

Tune the beat, keep the groove

432Hz MASTER shifts your beat from 440Hz to 432Hz with tempo untouched, so the drums and the groove stay exactly where you built them.

See 432Hz MASTER

Frequently asked questions

Should I make my beats at 432Hz from the start?

Build at 440Hz and retune at the end. Designing around an unusual reference limits your options for tempo, sample libraries and collaborators, while retuning a finished beat takes seconds.

How do I tune a beat to 432Hz without changing tempo?

Use a pitch shifter or retuner that preserves duration. Load it on the master bus and set the reference to A = 432Hz. The whole beat shifts down by about 32 cents and the tempo stays put.

Will tuning my beat to 432Hz change my kick drum pitch?

Yes. Everything moves down by about 1.8 percent, so a 55Hz kick lands near 53.5Hz. That usually reads as a deeper, heavier low end.

Can I make both a 432Hz and a 440Hz version of the same beat?

Yes, and it is a common release strategy. Print once at 440Hz, then run it through 432Hz MASTER for the second version. Tempo is identical in both.

More from the atixUniverse blog